Bảng Mạch Phát Triển Stm32f103c8t6 Arm Stm32 Cho Arduino
₫ 127.800
Sản phẩm Bảng Mạch Phát Triển Stm32f103c8t6 Arm Stm32 Cho Arduino đang được mở bán với mức giá siêu tốt khi mua online, giao hàng online trên toàn quốc với chi phí tiết kiệm nhất,0 đã được bán ra kể từ lúc chào bán lần cuối cùng.Trên đây là số liệu về sản phẩm chúng tôi thống kê và gửi đến bạn, hi vọng với những gợi ý ở trên giúp bạn mua sắm tốt hơn tại Pricespy Việt Nam
The main chip STM32F103C8T6 development board is pre-programmed with the test program at the factory. After power-on, the LED light will flash evenly and check whether the development board works normally.
− High 72MHz operating frequency
− Single cycle multiplication and hardware division
l memory
− from 64K or 128K bytes of flash program memory
− up to 20K bytes of SRAM
l clock, reset and power management
− 2.0 to 3.6 volt supply and I/O pins
− Power-on/power-off reset (POR/PDR), programmable voltage monitoring
(PVD)
− 4~16MHz crystal oscillator
− Embedded factory-tuned 8MHz RC oscillator
− Embedded 40kHz RC oscillator with calibration
− PLL that generates the CPU clock
− 32kHz RTC oscillator with calibration
l low power consumption
− Sleep, stop and standby modes
− V BAT supplies power to the RTC and the backup register
L2 12-bit analog-to-digital converters with 1us conversion time (up to 16
− Conversion range: 0 to 3.6V
− Double sampling and hold function
− Temperature sensor
lDMA:
− 7-channel DMA controller
− Supported peripherals: timer, ADC, SPI, I 2 C and
USART
l Up to 80 fast I/O ports
− 26/37/51/80 I/O ports, all I/O ports can be mapped to
16 external interrupts; almost all ports can tolerate 5V letters
number
l Debug mode
− Serial single-wire debugging (SWD) and JTAG interface
l Up to 7 timers
− 3 16-bit timers with up to 4 timers per timer
Input capture/output compare/PWM or pulse count channels
And incremental encoder input
− 1 16-bit with dead zone control and emergency brake for motor
Controlled PWM Advanced Control Timer
− 2 watchdog timers (independent and window type)
− System time timer: 24-bit self-decreasing counter
l up to 9 communication interfaces
− Up to 2 I 2 C interfaces (supports SMBus/PMBus)
− Up to 3 USART interfaces (supporting ISO7816 interface,
LIN, IrDA interface and modem control)
Up to 2 SPI interfaces (18M bits/sec)
− CAN interface (2.0B active)
− USB 2.0 full speed interface
lCRC calculation unit, 96-bit chip co
− High 72MHz operating frequency
− Single cycle multiplication and hardware division
l memory
− from 64K or 128K bytes of flash program memory
− up to 20K bytes of SRAM
l clock, reset and power management
− 2.0 to 3.6 volt supply and I/O pins
− Power-on/power-off reset (POR/PDR), programmable voltage monitoring
(PVD)
− 4~16MHz crystal oscillator
− Embedded factory-tuned 8MHz RC oscillator
− Embedded 40kHz RC oscillator with calibration
− PLL that generates the CPU clock
− 32kHz RTC oscillator with calibration
l low power consumption
− Sleep, stop and standby modes
− V BAT supplies power to the RTC and the backup register
L2 12-bit analog-to-digital converters with 1us conversion time (up to 16
− Conversion range: 0 to 3.6V
− Double sampling and hold function
− Temperature sensor
lDMA:
− 7-channel DMA controller
− Supported peripherals: timer, ADC, SPI, I 2 C and
USART
l Up to 80 fast I/O ports
− 26/37/51/80 I/O ports, all I/O ports can be mapped to
16 external interrupts; almost all ports can tolerate 5V letters
number
l Debug mode
− Serial single-wire debugging (SWD) and JTAG interface
l Up to 7 timers
− 3 16-bit timers with up to 4 timers per timer
Input capture/output compare/PWM or pulse count channels
And incremental encoder input
− 1 16-bit with dead zone control and emergency brake for motor
Controlled PWM Advanced Control Timer
− 2 watchdog timers (independent and window type)
− System time timer: 24-bit self-decreasing counter
l up to 9 communication interfaces
− Up to 2 I 2 C interfaces (supports SMBus/PMBus)
− Up to 3 USART interfaces (supporting ISO7816 interface,
LIN, IrDA interface and modem control)
Up to 2 SPI interfaces (18M bits/sec)
− CAN interface (2.0B active)
− USB 2.0 full speed interface
lCRC calculation unit, 96-bit chip co